Red color technology: SHORANGE look

In this technology, we tell you step by step how to do the haircut and coloring that you see in the photo, as well as what products you will need for this. You can take it and do it!

Coloring

1. Apply NaYo 8.44 + NaYo Cream Activator 30 Vol to the roots and along the length.

2. Create wavy areas.

3. Inside the sections, select 3 cm strands and apply Lunex Restore + Lunex Decap Super + Uni.Color Oxi 30 Vol. After the exposure time has expired, wash everything off and dry your hair.

4. Apply Lunex Colorful yellow to the strands. After 10 minutes, rinse and apply Lunex Colorful orange to all hair.

A haircut

1. Separate the area from the outer end of the right eyebrow to the outer end of the left. In the front part, select a circular area of 3 cm.

2. In the first zone, select vertical strands and perform medium graduations using a razor, creating a soft perimeter. We cut along the movable guide strand. In the second zone, we select the zone from the inner end of the left eyebrow to the inner end of the right and cut it using a soft point cut. Thus, we create the center of the bangs. Then we connect the bangs with the side parts and structure them. In the third zone, we make partings crosswise and select a small round area on the top of the head. We make 4 cuts at the outer points of the cross, slightly separating the area from the perimeter.

3. Using the previously created guide, select strands no more than 1 cm wide parallel to the floor. We continue to work over the entire head and perform medium graduations using a soft point cut.

4. We structure on dry hair: using a deep point cut in the first two zones, using the “flower” technique in the central one.