Step-by-step cutting and coloring technology from TM Framesi
Summer look
A haircut always complements the coloring and vice versa. Therefore, this material contains two step-by-step technologies: both convenient cutting and beautiful coloring.
The presented image from the Utility Glam collection (spring-summer 2019) from TM Framesi is the best choice for the summer period, because of the copper-red shade and the effect of beach waves on the hair. Your Hair magazine chose the most romantic look from the entire collection and shared step-by-step dyeing and cutting technology.
Haircut technology
1. We perform division into sectors. Apply BY CUTTING LOTION to easily separate hair into zones and segments.
Sector A – we form a triangle from ¾ of the brow ridge to the highest point of the head.
Sector B and C – draw a line from ear to ear through the center of the head and separate a 2-centimeter strand above the ears.
Sector D and E – draw a line from the middle of one ear to the middle of the second ear through the occipital protuberance.
2. We cut sectors E and C: we create a square perimeter using the pointcut technique at the level
middle of the neck with right angles.
3. We cut sectors B and D: we select the strands by making radial partings, twist them into strands and go through them, biting with the tips of the scissors from the middle of the length, focusing on the length obtained on the neck.
4. We cut sector D: focusing on the length of the hair obtained on the occipital protuberance, we divide the hair into radial sectors and cut it using a square chopping technique with a perpendicular pull.
5. We cut sector B: having outlined the strands with a vertical parting, we shift the hair to the penultimate sector of zone D and cut it in a square using the chopping technique in accordance with the existing length.
6. We cut sector A: comb the hair along its natural flow and cut the length 2 cm below the level of the chin using the pointcut technique. Using a razor, using the pencil method we add lightness to the entire sector from the middle of the length to the ends.
Dyeing technology
We apply FRAMCOLOR 2001 6W (40 r) + 7TRP (20 r) as a base color.
7–9. We carry out the division: we draw a line from the forehead to the back of the head and from one ear to the ear, passing through the center of the head. We divide the four sectors with diagonal partings, as shown in the diagram. Lighten the length to level 7 using STRIKE4 LIFT IN AN INSTANT and tone with an alternative color. Base – FRAMCOLOR2001 9E (55 g) + 8TRP (5 g).